3.3V Low Level Trigger Relay Module Optocoupler Isolation Termina

1 channel 3.3v low level trigger relay module optocoupler isolation terminal bestep for arduino - products that work with official arduino boards Sale - Banggood.com

Description:
 
Normally open interface maximum load: AC 250V/10A, DC 30V/10A.
SMD optocoupler isolation, strong driving capability, stable performance; trigger current 5mA.
Fault-tolerant design, the relay will not move even if the control line is broken.
Power indicator (green), relay status indicator (red).
The interface is designed humanized, and all the interfaces can be directly connected by wiring terminals, which is very convenient.

Two module interface:
 
1. DC+: Connect the power supply positive pole (voltage 3.3V).
2. DC-: Connect the power negative pole.
3. IN: Low level (3.3V) control relay pull in.
 
Relay output terminal:
 
1. NO: Relay normal open, the relay suspends before pulling in, and then short-connect with the COM.
2. COM: Relay common interface
3. NC: Relay normal close, short connected with COM before pulling inand suspended after pulling in.
 
Package Included:

1 x 1 Channel 3.3V Relay Module

Comments

Post a Comment

Popular posts from this blog

nanoCH32V203 Dev Board

Image
These are all purchase variations of this page.  The chip is the new 10 cent RISC-V.  https://www.tindie.com/products/johnnywu/nanoch32v203-development-board/ https://www.tindie.com/products/johnnywu/wch-linke-debugger/ nanoCH32V203 Development Board WCH RISC-V Dual TYPE-C USB Interface LCD Interface SD Card Slot Open Source nanoCH32V203 is a development board made by MuseLab based on CH32V203C8T6 of QinHeng. It features dual TYPE-C USB interfaces, LCD interface and SD card slot on board, and can be programmed through the USB port which is convenient for prototype verification and development. Dual USB interface, USB1 supports Device, USB2 supports Host/Device Can be downloaded directly via USB without additional downloader Onboard 8MHz and 32.768K crystal oscillator FPC-12P cable connector, which can support common LCD (such as ili9341, st7789, etc.) SD card slot, which supports SD card reading and writing (SPI protoc ol) Kit 3: nanoCH32V203 Development Board x 1 + 20 Pin Header x 2 +
Read more

ESP-M3 Mini

Image
 https://www.aliexpress.us/item/2251832658774277.html Long-range Ultra-low Mini Ultra-Small ESP-M3 From ESP8285 Serial Wireless WiFi Transmission Module Fully Compatible With ESP8266 ESP8285 = ESP8266 + 1M Flash, so that it can withstand high temperatures up to 125 degrees Celsius! And the original ESP8266 source code program can be used to transplant. ESP-M3 module core processor using cost-effective chip ESP8285. The chip integrates the enhanced version of the Tensilica's L106 Diamond 32-bit core processor with on-chip SRAM in a smaller package. ESP8285 has a complete Wi-Fi network function, both can be used independently, can also be used as a slave from other host MCU running. When the ESP8285 hosting application, can be started directly from the external Flash. Built-in cache memory facilitates system performance and optimizes storage systems. In addition, ESP8285 only through the SPI / SDIO interface or I2C / UART port can be used as a Wi-Fi adapter, applied to any microcontr
Read more